RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: F4F
Showing results 1 to 13 of 13
Search took 0.01 seconds.
Forum: RC Jets
04-26-2022, 05:22 AM
Replies: 1,342
Views: 203,183
Posted By F4F

Very nice shots Erik! Thank you! The...

Very nice shots Erik! Thank you!

The protective pipes for start up is very good idea!
Got also a 140N turbine, should be enough for reserves.
Forum: RC Jets
04-25-2022, 10:16 PM
Replies: 1,342
Views: 203,183
Posted By F4F

Hi Phantom Pilots, moving forward with the...

Hi Phantom Pilots,

moving forward with the build and after reading a lot or too much about the curious tailpipe installation I am a bit lost

So Skymaster put somewhere or long time ago that...
Forum: RC Jets
03-17-2022, 12:31 PM
Replies: 1,342
Views: 203,183
Posted By F4F

I ordered the Jet Hangar 1/10 Full scale body. ...

I ordered the Jet Hangar 1/10 Full scale body.

It looks that it is updated and a bit different compared to the picture on the website. I think its a resin print. The 1/8 scale pilot from warbird...
Forum: RC Jets
03-17-2022, 12:28 PM
Replies: 1,342
Views: 203,183
Posted By F4F

Thank you! Good idea to go through the flaps...

Thank you! Good idea to go through the flaps :cool:
Forum: RC Jets
03-17-2022, 11:02 AM
Replies: 1,342
Views: 203,183
Posted By F4F

Yes, thank you for the mail. I will do it also...

Yes, thank you for the mail. I will do it also this way. But I cant see how you put your newest option the nav light wires into this wing ;)
Forum: RC Jets
03-17-2022, 10:46 AM
Replies: 1,342
Views: 203,183
Posted By F4F

Very good! How did you routed the cable? As is...

Very good! How did you routed the cable? As is told, my ribs out of Airex dont have any holes to get cables a easy way.
Forum: RC Jets
03-15-2022, 01:00 PM
Replies: 1,342
Views: 203,183
Posted By F4F

Hey, my fin got the 2 carbon rods as seen...

Hey,

my fin got the 2 carbon rods as seen here on the other builds but only one clamp on the aft rods. Fitment is good and now play at all. But your option also looks good.

I like the...
Forum: RC Jets
02-22-2022, 02:30 AM
Replies: 1,342
Views: 203,183
Posted By F4F

Hi all, where did you route the servo wires...

Hi all,

where did you route the servo wires for the wings? tried the way in the thread on the side of the outboard wing going forward but I think SM changed a bit within the last 10 years and cant...
Forum: RC Jets
02-06-2022, 12:56 PM
Replies: 1,342
Views: 203,183
Posted By F4F

I got a B140F but I think I will replace the...

I got a B140F but I think I will replace the center tank. I have quite good experience with CM Jets but have to complete the section/cockpit and rc panel first. But will be a custom tank.
Forum: RC Jets
02-04-2022, 09:46 AM
Replies: 1,342
Views: 203,183
Posted By F4F

Thanks! All fine, was a bit concerned about the...

Thanks! All fine, was a bit concerned about the 20mm at least at top of rudder.

I ordered the Kevlar upgrade tanks and planning the setup.

If somebody is interested I measured the capacity...
Forum: RC Jets
02-01-2022, 10:06 AM
Replies: 1,342
Views: 203,183
Posted By F4F

According my estimate yes. I am just curious...

According my estimate yes. I am just curious about the „manual“ that says min. 20mm.
Dont know where, on the lower end cause of its length it is quite more at the trailing edge.

Yes, but I dont...
Forum: RC Jets
02-01-2022, 12:00 AM
Replies: 1,342
Views: 203,183
Posted By F4F

Hi, I am also buidling the small xtremejets F4...

Hi, I am also buidling the small xtremejets F4 and this thread very useful!

I started with the wings - swapping gears because also installed the wrong way and painting the struts. Gear itself is...
Forum: RC Jets
04-04-2021, 06:39 AM
Replies: 1,342
Views: 203,183
Posted By F4F

dionysusbacchus Nice paint job aswell. Whats...

dionysusbacchus
Nice paint job aswell. Whats the actual seat hight with helmet and shoulder width of that pilots? Did you lowered the floor or removed the seat cushion? Thanks
Showing results 1 to 13 of 13


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.